Skip to main content

Plastic Injection

– Pre Hardened –

2738 VEXtra

Also known as P20 + Ni plastic mold steel suitable for rapid mold production, it is available in two hardness levels, one standard 33 HRc and the other (High Hard) 36 HRc.

Chemical Composition

NO DIN AISI C Si Mn P S Cr Mo Ni
V'1.2738 40CrMnNiMo8-6-4 P20+Ni 0.35-0.45 0.20-0.40 1.30-1.60 Max 0,02 Max 0,005 1.80-2.10 0.15-0.25 0.90-1.20

Material Properties

  • Distribution of uniform hardness throughout the cross section
  • Homogeneous internal structure with sufficient cleaning
  • Good polishability
  • Good designing ability
  • Weldability
  • Good workability despite pre-hardened
  • It has good nitriding properties
  • Recommended usage hardness is delivery hardness

Applications

  • It can be used as a core in all kinds of plastic injection molds of polymers up to A1 surface quality and not containing more than 10% reinforcement: Automotive trim molds, panels in white goods, etc
  • As mold holder, hot runner distributor
  • In extrusion molds of non-corrosive plastics
  • In the barrels of extrusion presses
  • Machine parts, wear plates
  • Plastic pressing is used in compression molds

Heat Treatment

HEAT TREATMENT TEMPERATURE
Soft Annealing 710-740°C
Stress Relieving 550-600°C
Hardening 840-870°C
Tempering 600-680°C

Physical Properties

20°C 100°C 350°C 700°C
Elastic Modulus [kN/mm²] 212 207 194 -
Thermal Expansion Coefficient [10ˉ6/K] - 11,7 13,3 14,0
Thermal Conductivity [W/mK] 35.2 35.7 35.5 -
Toughness 32 - - -
Strength [N/mm²] 937 - - -

Delivery Condition

The hardness level of the pre-Hardened grades is shown as below. The hardness’ guaranteed is only on the surface of the blocks. The hardenability of the 2738 is not perfect and the hardness lost at core is around 3-4 Hrc.

MATERIAL BRINELL HARDNESS HRc N/mm2
1.2738 280-320 30-34 965-1085
1.2738 HH 320-350 34-38 1085-1200

Tempering Graph